Doc's latest activity

Thanks guys, I ended up straightening after I looked at it again it really was not bad. I put it between 2 pieces of 2x4 and clamper it...

check Ebay. I've found some part there that I could not find anywhere else.

I had the same issue on my boat a few years back: the crappy plastic shifter failed internally. The "fix" was a new throttle by eastern...

Look at a late 90s "SS" Chaparral with a fiberglass floor. They are really good, basic boats like yours that are well made, reliable...

I think this one is stern mount but not sure if it will push your boat 5mph...

Here is a bow mount trolling motor. https://www.basspro.com/p/minn-kota-powerdrive-bow-mount-bluetooth-trolling-motor

I had the same problem years ago. They do make a bolt on repair skag. Or at lest they did 10 years ago. If you try to bend back, you...

I believe the main purpose of the skag is to protect the prop. It took a lot of force to bend it, it will take a lot of force to bend it...

I had a little piece on the bottom of mine broke off. thought of covering it but like you, I preferred not to drill into it. So I ran...

In the other posting showing me at sunset, you'll take notice that I'm standing up. There was a lot of debris that day. Sharp turns here...

Thank you for your efforts. You always have to be on the lookout for those submarines. THe only problem you have at night, is you can't...

Actually it found me. I am anchored out in Lake Erie. Been here a couple of hours. Wind picks up a bit and as I’m observing wave...

Along with the rpms, I use my gps also, which will give me my speed.

Extra caution today out on the water, do not overload, safety first.

I boat on the Ohio River. I could clear the speedo pickup but before the day was out it would be plugged again. RPM's give me a good...