Iggy's latest activity

I don't know if this helps. The battery switch will isolate the two batteries or banks. With the ARC connected between them and if the...

Do the math. Load and distance to the size wire needed. I always go up a size to be safe.

Personally, I would not use an isolator. Not all, but most have a 0.6V drop. Which means the battery only comes close to be fully...

Sounds good. At least there are some hours on the new motor. It's broke in. If it runs out good on your test run I'd suggest having...

Launched it today. That front roller moved up it worked a lot better. I’ll have to try jacking it up in the fall when she’s back out

I went with rollers, one reason was cleaning and painting. With rollers I would clean and repaint the bottom. than move the boat a few...

Almost any boat trailer in the 25 foot range would work. As Denny pointed out, it needs to have the bunk or rollers adjusted to fit the...

Either the port or starboard side as far away from the center prop wash bubbles as possible, or you can put a thru hull unit in.

Then I would use another power source. If it works after that. Then you ether have a bad connection or not enough current getting to the...

Was there voltage?

The next thing, use a meter and make sure the Simrad power cord has 12V on the pins. Oh,

On my Simrad, you must hold down the power button until you see the 2nd Simrad logo come up. Other wise it turn off. Personally, I...

I am sure any off the shelf ones are hard to find. I would go to a canvus guy for a custom setup. Its easy to add poles, but the canvus...

Great Job!

That sucks! But since you have it open. Can you add a door? Not seeing the sink, can you drill holes on the rim? Then screw it down and...