Recent content by trhoad

I didn’t install a new fuel sensor, just used a new one to troubleshoot.Your right I think it maybe easier to just buy the garmin fuel adapter. Thx

Ok I bought a new fuel sender and hooked the two wires up to the the wires from helm and garmin gauge still reads full. As far as I know the sending wiring is channeled with the merc harness to a junction box and then converted through my gateway. Not sure what to test next??

I’m guessing that my engine wiring/fuel sender is going to a converter. I would amagine that my gateway is plugged into the other end of that converter then run to the TBone.

Everything has been working fine since 2019 when I bought this boat new. I wonder if Chaparral would have a wire diagram.

My setup is I have a nmea2000 back bone with a yellow power cord connected along with a gateway. I have two black cords connecting to each garmin units. I have a double screen garmin setup mounted/sealed into dash. The fuel sender cord is running in same housing from tank area to helm area. This...

My setup is I have a nmea2000 back bone with a yellow power cord connected along with a gateway. I have two black cords connecting to each garmin units. I have a double screen garmin setup mounted/sealed into dash. The fuel sender cord is running in same housing from tank area to helm area. This...

I have a 2019 277ssx i/o. My fuel display on my Garmin is always showing full. My marina fixed my trim tabs, saying there was a starboard actuator short. They replaced a indicator switch. Would that have anything to do with why my fuel display is showing full?