Steering wheel bolt pattern

[Ontariochaparral]

Does anyone know the bolt pattern? Is it a standard auto bolt pattern. I want to replace the standard wheel in my 350.

 

[Denny]

You should be able to pop off the center cap and it will give you the answer.

 

[Ontariochaparral]

You should be able to pop off the center cap and it will give you the answer.

Yes, but she is four hours away 😉

 

[Denny]

Not sure about the new autos, but the old ones were held on with one nut.
When I changed mine, there were 6 or 8 allen screws holding it on.
Try Cecil Marine they may have the answer.
Google this, it will either help or confuse you more.
(boat steering wheel bolt patterns)

 

[ags]

 

[Ontariochaparral]

Cool thanks, now if I had the center to center distance I could figure out the pitch circle. Heading to boat this weekend. I will update this post later as it might be useful for someone.

 

[ags]

Cool thanks, now if I had the center to center distance I could figure out the pitch circle. Heading to boat this weekend. I will update this post later as it might be useful for someone.
It appeared to be 1", unless it's metric. If you need it sooner, I'll be there again tomorrow.

 

[Ontariochaparral]

Thanks much appreciated, wife said I can't get the wheel just yet 😉. We are taking a month to drive her home and I will probably replace this winter.

 

[Bt Doctur]

You normally loosen the nut, slightly pull upward and strike the nut to remove the wheel from the tapered shaft